Parts #97

Traxxas Anti-Squat Wedges fit the Nitro Slash and install under the rear suspension arm mounts. They adjust the amount of rear anti-squat. The set has two 1.5-degree wedges and two 3-degree wedges.

These Traxxas 36 mm Turnbuckles are threaded links whose length you adjust by turning them. They come as a pair with aluminum spacers. Fits the Drag Slash, Nitro Slash and Slash VXL as a replacement part, and the Bandit as an accessory part.

Traxxas 54 mm Turnbuckles replace non-adjustable camber links with metal turnbuckles, so you can adjust camber on Traxxas trucks. The set includes 2 threaded turnbuckles and 2 aluminum spacers. Requires 2742 rod ends/ball connectors, which are not included.

The Traxxas Long/Short Rod End Set holds replacement rod ends for your RC car. It has 16 long ends (19 mm), 4 short ends (17 mm), 18 hollow ball connectors and 2 ball screws. The set does not fit the Sledgehammer, original Hawk, Cat, or Bullet.

Traxxas Long Half Shafts pass drive on to the wheels of your RC car. The set has two external shafts and two internal-splined shafts, all white nylon and telescoping, plus four aluminum crosses.

Traxxas Steel Rear CV Driveshafts pass drive on to the wheels. Steel constant velocity shafts offer the ultimate in torque handling and efficient power transfer. The outer U-joints are lubricated and sealed by a rubber boot.

Traxxas Rear Stub Axle Carriers are the standard version of this part and hold the axle the wheel turns on. You get two carriers, molded of black nylon.

Traxxas Blue Aluminum Axle Carriers (L&R) are optional stub axle carriers. A stub axle carrier holds the wheel axle and ties the wheel into the suspension. They fit the Rustler 4X4 VXL Ultimate, Slash 4X4 VXL Ultimate, Nitro Slash and Stampede 4x4.

The Traxxas Half Shaft Pro Pack holds six sets of telescoping half shafts, which carry drive to the wheels. Each set has an internal shaft that slides in an external-splined shaft. They are white plastic and for use on Traxxas trucks.

Traxxas PTFE-Coated Washers come as a set of 20 black plastic replacement washers for use with bearings. They are used on the axles and in the transmission. Each measures 5x8 mm and is 0.5 mm thick.

This Traxxas Slipper Clutch Shaft replaces a worn or damaged original in the slipper clutch. It fits the Traxxas Rad 2, TRX-1, Hawk 2, TRX-T Eagle, Blue Eagle, and Blue Eagle LSII. The package includes the shaft with the roll pin installed, a slipper spring and a nylon-insert aluminum locknut.

The Traxxas Slipper Clutch Tension Spring fits the Nitro Slash and keeps tension on the slipper clutch. It is the replacement set for Traxxas kits that have slipper clutches. A white spur gear bushing and a 4mm locknut with nylon insert come with it.