Parts #2

Traxxas TiN-Coated Long Shock Shafts are hardened steel with a brass-colored titanium nitride coating and a micro-polished finish. The box holds two, made for long Ultra Shocks™.

Traxxas Silicone Diaphragms for Ultra Shocks™ come as a set of four, replacing worn or damaged originals. Each diaphragm seals the oil inside an Ultra Shock. The diaphragms fit the Slash, Rustler, Stampede and T-Maxx 3.3, and also work well with Associated aluminum shocks.

The Traxxas Servo Saver protects the steering servo against impacts and replaces a damaged or worn one. It fits 25T spline servo gears, and 23T and 24T spline adapters come with it. A new spring and a mounting screw are included.

This brass pinion gear sits on the motor shaft and passes motor power on to the drivetrain. It fits 3 mm motor shafts and comes with 1 set screw. The gear fits Traxxas Slash, Rustler, Stampede and E-Revo 2.0 models.

Traxxas 54 mm Turnbuckles replace non-adjustable camber links with metal turnbuckles, so you can adjust camber on Traxxas trucks. The set includes 2 threaded turnbuckles and 2 aluminum spacers. Requires 2742 rod ends/ball connectors, which are not included.

The Traxxas Long/Short Rod End Set holds replacement rod ends for your RC car. It has 16 long ends (19 mm), 4 short ends (17 mm), 18 hollow ball connectors and 2 ball screws. The set does not fit the Sledgehammer, original Hawk, Cat, or Bullet.

Traxxas Steel Rear CV Driveshafts pass drive on to the wheels. Steel constant velocity shafts offer the ultimate in torque handling and efficient power transfer. The outer U-joints are lubricated and sealed by a rubber boot.

Traxxas Rear Stub Axle Carriers are the standard version of this part and hold the axle the wheel turns on. You get two carriers, molded of black nylon.

The Traxxas Slipper Clutch Tension Spring fits the Nitro Slash and keeps tension on the slipper clutch. It is the replacement set for Traxxas kits that have slipper clutches. A white spur gear bushing and a 4mm locknut with nylon insert come with it.

The Traxxas Machined 30-Tooth Idler Gear is an optional aluminum part that passes drive between the gears it meshes with. It is hard anodized and more precise than standard gears, for less wear and friction.

This Traxxas replacement gear set restores the performance of your 2070 or 2075 servo. Bearings are included in the box. It does not fit 2075-series metal-gear servos.

Traxxas 2056, 2075 Servo Case & Gaskets is a replacement waterproof case that restores your servo to fully-waterproof condition. It includes upper, lower, and middle sections with new o-rings and seals. The case fits 2075X and 2075R servos.